Canon imaqeRunner 1019J Advanced Operation Manual page 69

Advanced Send
1
Features
Interface Settings
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
Ethernet Driver
You can specify the communication method and Ethernet
connection type.
1.
Press [Additional Functions].
2.
Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set,
enter the System Manager ID and System Password using the
numeric keys, then press [Log In/Out].
3.
Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4.
Press [ ] or [ ] to select <ETHERNET
DRIVER>, then press [OK].
5.
Confirm that <AUTO DETECT> is displayed,
then press [OK].
Back Previous
6.
Press [ ] or [ ] to select the desired
detection method, then press [OK].
<AUTO>: Automatically determines the communication mode
(Half duplex/Full duplex) and Ethernet type (10Base-T/100Base-
TX). Skip to step 11.
<MANUAL>: You have to manually specify the communication
mode and Ethernet type.
NOTE
If you reconnect the network cable (for example, reconnect the
cable to a different Ethernet hub) with the power on, the Auto
Detect function will not work even if you set <AUTO DETECT>
to <AUTO>. (Connect the cable with the power off.)
7.
Confirm that <DUPLEX> is displayed, then
press [OK].
8.
Press [ ] or [ ] to select the desired
communication method, then press [OK].
<HALF DUPLEX>: Sends and receives alternately.
<FULL DUPLEX>: Sends and receives simultaneously.
TOP
Next
3-8