Appendix - Canon imaqeRunner 1019J Advanced Operation Manual

Advanced Send
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8

Appendix

9
Table of Contents
Index
22.
Use [ ], [ ], or numeric keys to set the
interval at which you want to check the POP
server for incoming e-mail, then press [OK].
NOTE
If the interval is set to 0, the POP server is not checked
automatically. For instructions on how to manually check the
POP server, see "Checking the Arrival of I-Fax," on p. 5-5
23.
Press [Stop] to return to the standby mode.
24.
Restart the machine.
Startup Time Settings
If you connect the machine to a switching hub, it may not be able
to connect to a network even though your network settings are
set correctly.
This occurs because the spanning tree process performed
between switching hubs prevents them from communicating
with each other immediately after the machine connects to a
switching hub.
In this case, use the following procedure to delay the startup of
network communication.
Back Previous
1.
Press [Additional Functions].
2.
Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set,
enter the System Manager ID and System Password using the
numeric keys, then press [Log In/Out].
3.
Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4.
Press [ ] or [ ] to select <STARTUP
TIME SET.>, then press [OK].
5.
Use [ ], [ ], or numeric keys to set the
time period required to delay the startup of
network communications for the machine,
then press [OK].
You can enter the value from 0 to 300 (seconds).
6.
Press [Stop] to return to the standby mode.
7.
Restart the machine.
TOP
Next
3-21