Canon imaqeRunner 1019J Advanced Operation Manual page 186

Advanced Send
1
Features
The documents you sent are too light.
Advanced Copy
Features 2
Network
3
Remote UI
4
Sending of documents is too slow.
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
Q Is the density set to the <–LT> side?
A Set the density to the <DK+> side.
Q Are the scanning components of the machine
clean?
A Make sure the scanning components are clean.
Q Is the resolution set to <FINE>, <SUPER FINE>,
or <ULTRA FINE>?
A Setting the resolution to <STANDARD> reduces
the sending time.
Q Is Error Correction Mode (ECM) set to <ON>?
A Because ECM corrects errors during a
transmission, any problems on the line can mean
that the transmission will take extra time. Set ECM
to <OFF>.
Back
Cannot send using Error Correction Mode (ECM).
Q Does the recipient's machine support ECM?
A If the recipient's machine does not support ECM,
the document is sent in normal mode without error
checking.
Errors occur frequently while sending.
Q Are the telephone lines in poor condition, or do
you have a bad connection?
A Check if there is a device nearby that interferes
with signal transmission (e.g., microwave oven).
A Lower the transmission speed. (See Chapter 14,
"Machine Settings," in the Basic Operation Guide.)
TOP
Previous Next
8-10