Canon imaqeRunner 1019J Advanced Operation Manual page 42

Advanced Send
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
13.
Use the numeric keys to enter the login
name, then press [OK].
You can enter up to 24 characters for the login name.
14.
Confirm that <PASSWORD> is displayed,
then press [OK].
15.
Use the numeric keys to enter the password,
then press [OK].
You can enter up to 24 characters (14 characters when <SMB> is
selected as the server protocol) for the password.
To register another one-touch key or coded dial code, repeat the
procedure from step 4.
16.
Press [Stop] to return to the standby mode.
Editing File Server Addresses
NOTE
You cannot change the server protocol setting (FTP or SMB) of the
destination registered in Address Book. To change the server protocol,
cancel the registration once, then register with the correct server
protocol again.
Back Previous
1.
Press [Additional Functions].
2.
Press [ ] or [ ] to select <ADDRESS
BOOK SET.>, then press [OK].
3.
Press [ ] or [ ] to select <1-TOUCH SPD
DIAL> or <CODED SPD DIAL>, then press
[OK].
4.
Press [ ] or [ ] to select a one-touch
key (01 to 23) or coded dial code (000 to 176)
you want to edit, then press [OK].
You can also select a one-touch key or coded dial code by
pressing the corresponding one-touch key, or [Coded Dial]
followed by the desired three-digit code.
5.
Press [ ] or [ ] to select the item you
want to edit, then press [OK].
You can edit <NAME>, <HOST NAME>, <FILE PATH>, <LOGIN
NAME>, and <PASSWORD>.
6.
Press [ ] repeatedly to go back to the
character you want to edit, then press [Clear].
To delete the entire entry, press and hold [Clear].
TOP
Next
1-21