Baseboard - Fujitsu PRIMERGY RX600 S4 User Manual

Chapter 1 Overview

1.3.4 Baseboard

a
l
k
a SAS array controller card connector
This is a connector for the SAS array controller card installed as a standard feature.
b SATA connector
Connect a SATA cable of the internal DVD-ROM unit.
c USB connector
When a 5-inch internal device option (USB) is installed, connect the USB cable.
d Memory board slot C and D
Install memory board C and D. Memory modules are in pairs on this server. Install each of the
pair in the same numbered memory slot of the memory board C and D respectively.
e I/O riser card slot
Install an I/O riser card. On the I/O riser card, there are three LAN ports: one for Remote
Management Controller and the rest for I/O riser LAN.
f Memory fan connector
On the rear side of the server, four memory fans are installed in total.
g Jumper
For jumper settings, refer to "7.1 Jumper Settings" ( pg.150).
28
b c d
j i
e
f
g
h
f