Fujitsu PRIMERGY RX600 S4 User Manual page 33

1
Make sure the CD/DVD drive is empty.
2
Turn on the display and peripheral devices.
3
Press the system power button on the front of the server.
The server's system power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed.
"8.2.2 Error Messages" (pg.184)
It may take a few seconds until the server is turned on.
The time to turn on the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
To display the [Boot] menu where you can change the boot drives, press the [F12] key right after the
POST memory amount check.
" How to start BIOS Setup Utility" (pg.151)
System power LED
System power button
3.4 Serious Error Handling (ASR)
"
PRIMERGY RX600 S4 User's Guide
System power
LED is lit green
in ServerView User's Guide
" " ".
33