Table of Contents
Advertisement
The page as shown in the following figure appears.
The following table describes the parameters and buttons in this page:
Field
IP QoS
QoS Policy
Schedule Mode
Source IP
Source Mask
Destination IP
Destination
Mask
Source Port
Disable or enable QoS. By default, IP QoS is disabled. You
need to enable IP QoS, and then you can configure the
parameters in this page.
You can select Stream based, 802.1p based, or DSCP
based.
You can select Strict prior or WFQ (4:3:2:1).
Enter the IP address of the source data packet.
Enter the subnet mask of the source IP address.
Enter the IP address of the destination data packet.
Enter the subnet mask of the destination IP address.
Enter the port of the source data packet.
92
www.encore-usa.com
Description
Advertisement
Table of Contents
