Port Mapping - Encore ENDSL-4R5G User Manual

The following table describes the parameters and buttons in this page:
Field
RIP
Apply Changes
Interface
Receive Version
Send Version
Add
Delete
RIP Configuration
List
Choose Advance > Port Mapping, the page as shown in the following figure appears. In this
page, you can bind the WAN interface and the LAN interface into the same group.
Select Enable, the router communicates with other
RIP-enabled devices.
Click it to save the settings in this page temporarily.
Select the interface of the router that uses RIP.
Select the interface version that receives RIP messages.
You can select RIP1, RIP2, or Both.
 RIP1 indicates that the router receives RIP v1
messages.
 RIP2 indicates that the router receives RIP v2
messages.
 Both indicates that the router receives both of RIP v1
and v2 messages.
Select the working mode for sending RIP messages. You
can select RIP1 or RIP2.
 RIP1 indicates that the router broadcasts RIP v1
messages only.
 RIP2 indicates that the router multicasts RIP v2
messages only.
Click it to add a specified RIP interface to the RIP
Configuration List.
Select a row in the RIP Configuration List and click it to
delete the row.
A list of the router interfaces that enable RIP.

4.6.3 Port Mapping

89
www.encore-usa.com
Description