Table of Contents
Advertisement
Field
Enable IGMP
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Type
Local IP Address
Remote IP Address
Net mask
Unnumbered
Add
Modify
Current ATM VC Table
Description
the Internet normally, you must add a route on the
uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is required to enable NAPT.
Enable or disable IGMP.
Enter the correct user name for PPP dial-up, which is
provided by your ISP.
Enter the correct password for PPP dial-up, which is
provided by your ISP.
You can select Continuous, Connect on Demand,
or Manual.
If you select Connect on Demand, you need to enter
the idle timeout time. Within this preset minutes, if the
router does not detect the flow of the user
continuously, the router automatically disconnects the
PPPoE and PPPoA connection.
You can select Fixed IP or DHCP.
If you select Fixed IP, you need to enter the local
IP address, remote IP address and subnet mask.
If you select DHCP, the router is a DHCP client,
the WAN IP address is assigned by the remote
DHCP server.
Enter the IP address of WAN interface that is
provided by your ISP.
Enter the gateway IP address that is provided by your
ISP.
Enter the subnet mask of the local IP address.
Select it to enable IP unnumbered.
After configuring the parameters in this page, click it
to add a new PVC setting into the Current ATM VC
Table.
Select one PVC settings in the Current ATM VC
Table, and then modify the parameters of this PVC.
After setting, click it to take this PVC setting into
effect.
This table shows the existed PVC settings. It shows
the
Interface
name,
encapsulation mode, local IP address, remote IP
address and other information. The maximum item of
this table is eight.
59
www.encore-usa.com
channel
mode,
VPI/VCI,
Advertisement
Table of Contents
