Encore ENDSL-4R5G User Manual page 49

Field
Enable or disable WLAN.
WLAN
You need to enable WAN interface only if you want to use
Interface
WLAN and configure the parameters in this page.
Select the working mode of the router. You can select 802.11b,
Band
802.11g, or Mixed (802.11b/11g).
The service set identification (SSID) is a unique name to identify
the router in the wireless LAN. Wireless stations associating to
SSID the router must have the same SSID. Enter a descriptive name
that is used when the wireless client connecting to the router. By
default, the SSID is ENDSL-4R5G.
Configure the wireless encryption mode. You can choose None,
WEP, WPA (TKIP), WPA (AES), WPA2 (AES), WPA2 (TKIP),
or WPA2 Mixed.
 Wired equivalent privacy (WEP) encrypts data frames
 Wi-Fi protected access (WPA) is a subset of the
Encryption
 WPA2 Mixed is the collection of WPA and WPA2 encryption
Key differences between WPA and WEP are user authentication
and improved data encryption.
Set the encryption to WEP, the page as shown in the following figure appears.
The following describes the parameters of WEP encryption:
Field
Key Length
Key Format
before transmitting over the wireless network.
IEEE802.11i security specification draft.
modes. The wireless client establishes the connection
between the router through WPA or WPA2.
Select the WEP key length. You can select 64-bit or 128-bit.
 If the key length is set to 64-bit, you can select ASCII (5
characters) or Hex (10 characters).
 If the key length is set to 128-bit, you can select ASCII
48
www.encore-usa.com
Description
Description