Table of Contents
Advertisement
(6)
I need to upgrade the Firmware.
Answer.
In order to upgrade the Firmware with the latest features, check your local dealer
or ISP for technical support. Before proceed the upgrading process, check the following
details:
1.
Download the latest Firmware and save at your pointed location.
2.
Read the firmware release note carefully before proceed the upgrading
process.
3.
Refer to Tools - Update section for the upgrading process.
(7)
Testing LAN path to your Wireless ADSL 2+ Modem Router.
Answer.
To verify whether the LAN path from your PC to your Wireless ADSL 2+ Modem
Router is properly connected, you can "Ping" the LAN IP address of Wireless ADSL 2+
Modem Router with the following procedure:
1.
From the Windows toolbar, click "Start" and select "Run".
2.
In the Open field, type "Ping 192.168.1.1" and click "OK".
3.
If the path is working, you should see the message in the following format:
Reply from 192.168.1.1 bytes = 32 time < 10ms TTL = 60
4.
If the path is not working, you should see the following message:
Request timed out
If the path is not functioning correctly:
1.
Make sure the LAN port LED indicator is on.
2.
Check whether you are using the correct LAN cable.
3.
Check your Ethernet adapter installation and configurations.
4.
Verify that the IP addresses for your Wireless ADSL 2+ Modem Router and
your workstations are correct and the IP addresses are on the same subnet.
111
www.encore-usa.com
Advertisement
Table of Contents
