Table of Contents
Advertisement
Field
The following describes how to configure the PPPoE (0/32) connection:
Step 1
Set the VPI to 0, VCI to 32.
Step 2
Select PPPoE as the channel mode.
Step 3
Enter the user name and password for PPPoE dial-up, which are provided by your
ISP.
Step 4
Click
in the Current ATM VC Table to check or edit the setting.
The page as shown in the following figure appears. In this page, you can configure
parameters of this PPPoE PVC setting.
The following table describes the parameters and buttons in this page:
Field
Protocol
ATM VCC
Login Name
Password
Authentication Method
Connection Type
Idle Time (s)
Click it, the PPP Interface-Modify page appears.
You can modify the PVC's parameters.
It displays the protocol type used for this WAN
connection. In this example, it is PPPoE.
It displays the ATM virtual circuit connection assigned
for this PPP interface (VPI/VCI).
The login name provided by your ISP.
The password provided by your ISP.
You can select AUTO, CHAP, or PAP.
You can select Continuous, Connect on Demand, or
Manual.
If the connection type is set to Connect on Demand,
you need to enter the idle timeout time. Within the
60
www.encore-usa.com
Description
Description
Advertisement
Table of Contents
