Table of Contents
Advertisement
Click WAN, the page as shown in the following figure appears. In this page, you can configure
WAN interface of your router.
The following table describes the parameters in this page:
Field
Default Route Selection
VPI
VCI
Encapsulation
Channel Mode
Enable NAPT
4.4.2.1 WAN
Description
You can select Auto or Specified.
VPI is the virtual path between two points in an ATM
network. Its valid value is in the range of 0 to 255.
VCI is the virtual channel between two points in an
ATM network. Its valid value is in the range of 32 to
65535. (0 to 31 is reserved for local management of
ATM traffic)
You can select LLC or VC-Mux mode.
You can select 1483 Bridged, 1483 MER, PPPoE,
PPPoA, or 1483 Routed mode.
Select it to enable network address port translation
(NAPT). If you do not select it and you want to access
58
www.encore-usa.com
Advertisement
Table of Contents
