Table of Contents
Advertisement
The following table describes the parameters in this page:
Field
IP Address
Subnet Mask
Secondary IP
IGMP Snooping
Dynamic Host Configuration Protocol (DHCP) allows the individual computer to obtain the
TCP/IP configuration from the centralized DHCP server. You can configure this router as a
DHCP server or disable it. The DHCP server can assign information of IP address, IP default
gateway, and DNS server to DHCP clients. This router can also act as a surrogate DHCP server
(DHCP proxy) where it relays IP address assignment from an actual real DHCP server to clients.
You can enable or disable DHCP server or DHCP proxy.
There are three DHCP modes available: DHCP Server, DHCP Relay, and None. The following
describes them respectively.
Enter the IP address of LAN interface. Its valid value is in
the range of 192.168.1.1 to 192.168.255.254. The default
IP address is 192.168.1.1.
Enter the subnet mask of LAN interface. Its valid value is in
the range of 255.255.0.0 to 255.255.255.254.
Select it to enable the secondary LAN IP address. These
two LAN IP addresses must be in the different network.
Enable or disable IGMP snooping.
4.4.1.2 DHCP
52
www.encore-usa.com
Description
Advertisement
Table of Contents
