Table of Contents
Advertisement
Field
Data Rate
Broadcast SSID
Relay Blocking
Ethernet to
Wireless Blocking
Click WPS, the page as shown in the following figure appears.
Disable WPS: Select it to disable WPS. You need to enable WPS if you want to configure the
parameters in this page.
There are three methods for WPS authentication, you can choose one of them:
Press the WLAN/WPS button on the rear panel of the router for 3 seconds or more than
3 seconds.
connect to the device
In the encryption authentication, the wireless client
connects to the router through the shared key.
Select the transmission rate of the wireless data.
You can select Auto, 1 M, 2 M, 5.5 M, 11 M, 6 M, 9 M, 12
M, 18 M, 24 M, 36 M, 48 M, or 54 M.
Select whether the router broadcasts SSID or not. You can
select Enable or Disable.
Select Enable, the wireless client searches the router
through broadcasting SSID.
Select Disable to hide SSID, the wireless clients can
not search the SSID.
Wireless isolation. Select Enable option, the wireless
clients that are connected to the router can not
intercommunicate with each other.
Whether the wireless network can communicate with the
Ethernet network or not.
4.4.3.6 WPS
70
www.encore-usa.com
Description
Advertisement
Table of Contents
