Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 74

HOW TO INSTALL IN AN AIRCRAFT
THIS RESTRAINT IS SUITABLE FOR USE ON AN AIRCRAFT WHEN
INSTALLED AS DIRECTED.
HOW TO INSTALL USING AIRCRAFT LAP BELT
The child restraint must be used in accordance with the aircraft procedures, and any directions from the
aircraft operator, pilot or crew.
Some child restraints may not fit in smaller aircraft and can not be used with aircraft seatbelts that contain
airbags unless they can be disabled.
Inform the aircraft operator that a child restraint is intended to be used on the aircraft when booking the
flight as the child restraint may not be suitable for use in that operator's aircraft.
Follow the instructions of the flight crew or pilot.
For use of the child restraint in cars in countries other than Australia and New Zealand as follows:
(A) The child restraint may not be acceptable for use in cars.
(B) The user may need to consult the country's local authorities, car hire companies, car insurance
companies, etc. for advice.
TO FIT THE CHILD RESTRAINT TO THE
AIRCRAFT SEAT IN FORWARD FACING:
A. Set the recline position to fully upright. Position the
restraint in forward-facing mode and align centrally with the
chosen seating position. We recommend that you fit the
restraint nearest the window or in a middle seat if in centre
seating area, so it will not interfere with an adult exiting the
row of seats. If possible, lift the armrests out of the way to
improve access to installing the aircraft lap belt. However
airline staff will direct you to the desired seat position.
B. The top tether is not required to be used to fit the child restraint in an aircraft. Shorten the top tether
strap and store in its storage pocket. Attach the tether clip to the elastic loop provided on the restraint
as shown.
IMPORTANT:
When the tether hook is stored on the loop always remember to attach the
upper tether strap when reinstalling in the car.
74
Instructions for Installation & Use