Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 61

H. Fit the attachment clip on the upper anchorage strap to the anchor fitting
as shown. Make sure to remove as many twists as possible from the upper
anchorage strap.
Always attach the hook and remove slack
I. Tighten adjustable top tether strap by pulling adjustment
strap to remove slack as shown below, but do not over-
tighten causing the restraint base to lift off the vehicle seat.
J. Fold up excess strap and use the top tether pocket to store
excess strap away from child's reach.
IMPORTANT :
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by
the child.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE
THE TOP TETHER STRAP MAY FALL INTO A SPLIT IN
THE SEAT BACK OR OFF THE SIDE OF THE SEAT.
Always ensure that the car seatbelt is firmly restraining the
restraint on the vehicle seat.
ALWAYS ATTACH TOP TETHER HOOK AND REMOVE
SLACK IN THE TOP TETHER STRAP.
Check that the seatbelt is not twisted and the diagonal
belt is only clamped by the lock-off which is located on the
opposite side from the car seat buckle.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP DAMAGED BY
UNSECURED CARGO IN A COLLISION. SECURE OR REMOVE HAZARDOUS CARGO BEFORE
USING THIS CHILD RESTRAINT.
HOW TO INSTALL
Attachment Clip
Car's Anchor Fitting
Press
Pull Adjustment Strap
to remove slack
G
Roll up excess strap
and store in the
pocket attached to
the cover.
H
Instructions for Installation & Use
61