Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 46

HOW TO USE
PLACING CHILD INTO RESTRAINT
A. Ensure the headrest and shoulder straps are adjusted to the
correct height for your child (see page 43).
B. Slacken the top tether strap if not already slack and allow the
straps to fall to the sides of the restraint for easy access to
the child.
C. Loosen shoulder straps by pressing the harness adjuster and
pull both shoulder straps evenly. Pull out the desired amount
of slack.
D. Place the two harness tongues into the Buckle Tongue
Holder (if fitted).
With the EZ buckle system the harness buckle will flip
towards the harness adjuster for easier fitment next time you
put the infant in the carrier.
E. Place baby into child restraint lying on its back so that the
buckle is between the baby's legs. Ensure that baby's arms
and legs are free. Make sure baby is dressed to allow the
Harness Buckle to be pulled up between baby's legs e.g. a
jump suit.
NOTE: The headrest should be adjusted so that the wings on the
headrest or shoulder strap slots are just above the shoulders
but not below the shoulders.
CAUTION:
Do not harness an infant wrapped in a blanket or swaddled as this increases the risk of ejection and
injury or death in a crash. The harness needs to fit firmly to the baby, any blanket or other covering may
be placed over the harness after the harness is adjusted. Arms and legs must be free and not bound or
wrapped together. The legs must sit on each side of the crotch strap.
IMPORTANT :
Always adjust the height of the headrest thus the shoulder straps as the child grows.
46
Instructions for Installation & Use