Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 72

HOW TO REMOVE
REMOVING CHILD FROM RESTRAINT
A. Push and hold the harness adjustment lever while pulling both
shoulder harness straps to slacken harness to the desired
amount.
B. Press the red button on harness buckle, both harness tongues
will be released. Insert buckle tongues into harness tongue
holders to hold harness straps away from the child. Move each
shoulder strap aside.
To remove the seat refer to page 73 for ISOFLEX or below for
seatbelt installation.
REMOVE RESTRAINT FROM VEHICLE
FITTED WITH SEATBELT
A. Remove the top tether strap from pocket and fully
press top tether adjuster button (A) while pulling top
tether strap (B) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
B. Disengage the attachment clip from upper anchorage
fitting.
C. Store loose strap in the top tether storage pocket
provided on the cover.
D. Disengage the vehicle seatbelt buckle from any
lock-off devices on both sides of the restraint.
E. Disengage seatbelt from the restraint belt paths. Allow
seatbelt to feed back into seatbelt retractor.
72
Instructions for Installation & Use
Harness tongue
holders (where fitted)
Fully press Adjuster Button (A) while
pulling top tether strap (B) to lengthen.
Roll up excess strap
and store in the pocket
attached to the cover
to avoid tripping when
moving the restraint.
A
B