Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 51

DISCONNECT TOP TETHER AND
ISOFLEX CONNECTORS
To store the ISOFLEX connectors on the inside
of the seat wings.
A. Press the ISOFLEX strap adjuster button to
release tension on the straps.
B. Press each of the red release buttons on the
ISOFLEX connectors and remove them from
the vehicle ISOFIX low anchorages.
C. Fully lengthen the ISOFLEX strap and engage
each ISOFLEX connector onto its storage pin.
Remove slack but do not tighten. The storage
pin may be damaged if the strap is tightened.
D. Remove the excess tether strap from pocket
and fully press top tether adjuster button (A)
while pulling top tether strap (B) to slacken as
shown. In some vehicles loosening of the top
tether strap may be difficult. If so, try pushing
the restraint against the vehicle seat back
or slightly lifting the restraint to release the
tension.
E. Disengage the attachment clip from upper
anchorage fitting.
Store loose strap in the storage pocket
provided on the cover.
HOW TO REMOVE
C
Fully press Adjuster Button (A)
while pulling Top tether Strap (B) to
lengthen.
A
Instructions for Installation & Use
C
B
51