Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 64

HOW TO INSTALL USING ISOFLEX CONNECTORS
INSTALLING INTO THE CAR
USING ISOFLEX (IF FITTED) AND
TOP TETHER STRAP
C. Recline instructions are shown on page 28.
D. Press and hold the ISOFLEX strap adjuster
button and pull the connector strap to fully
lengthen. Repeat for both connector straps.
E. Place the restraint in the desired location on
the vehicle seat between the two ISOFIX low
anchorages. Ensure the child seat is against the vehicle seat
back as shown. Engage the ISOFLEX connectors into each
ISOFIX low anchorage. A click may be felt a green indicator
will show on the top of the ISOFLEX connector when it has
engaged. Pull the adjusting strap to remove most of the slack
on each side but do not tighten.
F. Push downwards on the armrests of the child seat to compress
the side of the seat into the vehicle seat. Whilst pushing, pull
on adjuster strap to remove all slack and tighten the ISOFLEX
strap. Repeat for the adjuster strap on the other side of the
restraint. The two tension indicators will show 'green' indicating
minimum tension has been applied.
IMPORTANT:
Do not attach the lower attachment connectors of two separate child restraints to the same ISOFIX
low anchorages in your car.
Always attach the top tether strap to the child restraint upper anchorage in your car.
Child restraint lower attachment connectors and the ISOFIX low anchorages in your car are designed to
withstand only those loads imposed by a correctly fitted child restraint.
64
Instructions for Installation & Use
Push down here
Pull ISOFLEX adjuster strap
to tighten
Tension indicators