Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 22

INSTALLATION METHOD
If you have purchased a restraint with ISOFIX lower anchorage straps then the restraint may be installed
by either the ISOFIX low anchorages or the seatbelt. If there are no ISOFIX low anchorages straps then
the restraint can only be fitted with the seatbelt.
Consult the car owner's handbook for location of top tether anchorage points.
If there is no child restraint anchor fitting or child restraint anchor point refer to pages 83 to 86 for the
installation of the anchor fitting as well as the use of extension straps.
An anchor fitting is required to attach the top tether strap to fully install the restraint to the vehicle. The top
tether strap must be used with this child restraint when used.
Select a seating position with a child restraint anchor fitting directly behind the seating position.
Determine if the vehicle ISOFIX Low Anchorages or Seatbelt will be used to secure the restraint
installation. The ISOFLEX connectors will need to be deployed from their storage location prior to adjusting
the seat recline angle to rearward facing mode.
SEATBELT OR ISOFIX COMPATIBLE
If not fitted with ISOFIX compatible straps this seat is suitable for fitting with seatbelt and top tether
strap.
If fitted with ISOFIX compatible straps the installation may be either seatbelt
and top tether strap or
ISOFLEX Connectors and top tether strap.
SEAT BELT WITH TOP TETHER STRAP
Use your vehicle seat belt and top tether strap to install this seat. Follow the directions outlined:
For Rearward Facing Use - Refer to page 29 to 35
For Forward Facing Use - Refer to page 59 to 62
ISOFLEX (if fitted) WITH TOP TETHER STRAP
Use your vehicles ISOFIX low anchorage points and top tether strap to install this seat. Follow the
directions outlined:
For Rearward Facing Use - Refer to page 36 to 41
For Forward Facing Use - Refer to page 63 to 65
22
Instructions for Installation & Use