Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 60

HOW TO INSTALL
INSTALLING INTO VEHICLE FORWARD FACING -WITH SEATBELT
A. Position the restraint in forward facing mode
and align restraint centrally with the chosen
seating position.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child restraint
used continuously. We recommend the use of
a long Messy Mat™or thick towel to keep the
vehicle seat in good condition.
B. Fully lengthen seatbelt. Insert seatbelt tongue
through the forward facing seatbelt path
(yellow), ensuring that the seatbelt is behind
the harness straps. Ensure the lap part of the
seatbelt is below the hooks as shown in Fig D.
C. Engage the vehicle seatbelt buckle and
tongue. Remove all slack from the lap part of
the seatbelt 1 by pulling sash belt 2.
D. Grasp the sash belt edge between thumb
and fingers in each hand. Slide the belt up
into the lock-off slot to the top of the slot. If
the sash belt is not slack it may not enter the
lock-off slot.
E. Pull the sash belt through the lock-off (if fitted)
to fully tighten the seatbelt. Pull the sash belt
firmly through the lock-off. The child restraint
should now be firmly fitted to the vehicle seat.
F. Always check all slack is removed from the
lap belt by pulling the sash belt through the
lock-off
G. Allow the excess sash belt to feed back into
retractor.
60
Instructions for Installation & Use
Slacken the sash
belt and feed into the
lock-off
Ensure lap part of
seatbelt is below
the hooks
E
2
Pull sash portion
of seatbelt to
remove slack
1
Lap seatbelt
C
D
Pull the sash belt
through the lock-off
(if fitted) to fully
tighten the seatbelt