Britax Safe N Sound Compaq MKII Instructions For Installation & Use page 30

HOW TO INSTALL
D. Fully lengthen seatbelt and through
REARWARD FACING
the blue
BELT PATH
between the restraint cover and the
restraint body through seatbelt slots in
restraint.
E. Engage seatbelt buckle and tongue.
Push down on the seat (by hand), whilst
pulling the sash belt firmly to tighten the
seatbelt. This will make the lap belt very
tight across the restraint. Whilst holding
the seatbelt tension, ensure to remove all
slack from lap part of seatbelt by pulling
sash belt. For retractor seatbelts, allow
excess belt to feed back into retractor.
NOTE: Seatbelt buckle and tongue must not
rest between restraint cover and restraint. If
seatbelt buckle is adjustable, adjust buckle as
low as possible away from the restraint.
30
Instructions for Installation & Use
opening feed the seatbelt
headrest trim end
Pass buckle tongue through slot here
Push down on the seat
Pass buckle tongue through slot here
Centre
panel flap