Table of Contents
Advertisement
6.6: Mounting the Nexus® External Output Modules
Connect multiple Output modules by inserting male RS485 side ports.into female ports, then using a
flathead screwdriver, screw each module into the next. Work from left to right.
If multiple modules are connected together, as shown in Figure 6.15, (or an individual module is
used) secure the mounting brackets to both ends of the group (or individual module) using the
screws supplied (#440 pan-head screws). Next, secure the brackets to a flat surface using a #8 screw
with a lock washer.
The Nexus® 1262/1272 meter will NOT supply power for the Output modules. You must use an
external power supply, such as the EIG PSIO (12V Output). Figure 6.12 shows the modules
mounted without a PSIO Power Supply; Figure 6.15 shows mounting with the PSIO.
Mounting Bracket
1.13" (28.57mm)
3 x 1.32" (33.27mm)
0.015" (0.37mm)
4.1" (104.14mm)
Mounting Bracket
Figure 6.12: Nexus® Output Modules Mounting Diagram, Overhead View
Mounting Brackets (MBIO)
Female RS-485 Side Port
Output Port
Male RS-485 Side Port
Figure 6.13: Nexus® Output Module Communication Ports
Doc # E151701
Electro Industries/GaugeTech
6-10
Advertisement
Table of Contents
