Table of Contents
Advertisement
3.5: Programmable Display Overview
The Programmable Display has three configurable modes with up to 16 screens each. The three
modes are displayed in auto sequence every 7 seconds. Using Communicator EXT, you can assign
up to 16 screens to each mode: any of the available screens can be used in any mode. You can also
assign a three-digit label to the mode. The three modes are:
• •
Configurable View Mode 1 - Replacing Normal Mode
• •
Configurable View Mode 2 - Replacing Circuit Diagnostic Mode
• •
Configurable View Mode 3 - Replacing Time of Use Mode
This feature allows you to determine what data will be displayed and in what order on the display.
Larger (.56") digits are displayed on many of the screens so that data is much easier to read.
View Mode 1 is the primary mode. The other modes, View Mode 2 and View Mode 3 are
accessed by swiping the Mode Switch twice. Test Mode is accessed by removing the cover
(POWER MUST BE OFF), powering up the meter and pushing the Test Button at any time.
View Mode 2 and View Mode 3 will automatically return to View Mode 1 after a user-set amount of
time without any action. Test Mode will automatically return to View Mode 1 after an amount
of time since the last user action with no energy accumulation (or) an amount of time since the last
user action plus the demand interval with energy accumulation. The values for the amount of time
since the last user action are set in the Miscellaneous screen of the User Inactivity Time Outs
section.
The Programmable Display can be edited through Communicator EXT even if the meter is not
connected to the computer. Refer to the next section (Section 3.6) for instructions.
See the Communicator EXT User Manual for additional details on programming and polling the
Nexus® 1262/1272 meter.
e
Electro Industries/GaugeTech
Doc # E151701
3-6
Advertisement
Table of Contents
