6.2.1: Battery Holder Detail
NOTE: It is very important to insert the replacement battery into the holder
correctly. Otherwise proper contact will not be achieved and the meter may
lose log memory and time functions.
•
STEP A: Make sure the + on the battery is facing UP and toward you.
Insert the RIGHT SIDE of the battery UNDER the 2 clips on the right side of the holder while
gently pushing the battery against the INSIDE RIGHT WALL of the battery holder (Arrow A).
STEP B: Gently push the LEFT SIDE of the battery in until it snaps into place (Arrow B).
•
6.2.2: Battery Safety and Disposal
Do not expose battery to temperatures above 100 degrees C. Do not incinerate, puncture, crush,
•
recharge, short-circuit or over-discharge battery.
Do not expose contents of battery to water or to high humidity for extended periods of time.
•
Dispose of batteries in accordance with local, state and federal hazardous waste regulations.
•
NOTE:
The replacement of the Modem Battery is detailed in section 5.4.4.
e
Electro Industries/GaugeTech
Figure 6.6: Battery Holder Detail
Doc # E151701
6-6