Table of Contents
Advertisement
∅
∅
Fig. 12.6: Switchboard Meter Cutout with Tolerance
NOTE: When the Switchboard cases are built, they are not exact. They are welded together and have
slight variations. For that reason we add Tolerance to the above Cutout Diagram (Fig. 12.6).
The dimensions shown are the exact measurements of boxes we have on hand that have been
measured. We added 1/16 " (+1.5875mm) for the cutout.
Please check DRILL HOLES for the mounting screw you are using. Check to see that the
mounting screw fits the box tightly enough to hold the box in place. You can use a washer for
a slightly smaller mounting screw.
12-5
Electro Industries/GaugeTech
Doc # E151701
Advertisement
Table of Contents
