Brake Pads; Accelerator Control - MV Agusta F4 BRUTALE 750 ORO Workshop Manual

BRAKE PADS

Check/substitute ¨
B
Check the condition and thickness of the brake pads
on the calipers.
Measure the thickness of the pad linings. If the thick-
ness of the linings is equal or less than the wear limit
shown below, replace the pads as described in chapter
H "Brakes".
Wear limit: 1 mm.
If the brake pads are substituted, it is neces-
sary to effectuate a proper running-in period
before reaching an optimal braking effi-
ciency.

ACCELERATOR CONTROL

Accelerator play check¨
The accelerator control should not be too tight or too
slack (excessive play) in its movement.
It must also be free of play and looseness when turning
it.
For optimum adjustment it is necessary to work on the
two upper nut adjusters (situated on the accelerator
handgrip).
The lack of play on the closure of the acce-
lerator (1) can stop the complete closing of
the throttle valve and the accelerator could
remain in the open position, thereby leaving
the engine with a fast tickover. It is the same
for the opening transmission (2).
Maintenance
At the first 1000 kilo-
metres and then very
6000 kilometres
At the pre-delivery
check, at the first 1000
kilometres and then
every 6000 kilometres
- 72 -
Front brake caliper
Rear brake caliper
Disc
Pads
Wear limit 1 mm
1