Setting The Panel's Device Number; Wireless Settings - Wireless Access Overview (Mvp-5150 Only); Dhcp - AMX MVP-5100 Operation/Reference Manual

Setting the Panel's Device Number

In the Protected Setup page:
1. Press the Device Number field in the Device ID section to open the Device Number keypad.
2. Enter a unique Device Number assignment for the device, and press Done to return to the Protected
Setup page. The Device Number range is 1 - 32000, with the Master assigning the panel a new
Device Name once connected, and the default is 0.
3. Press Reboot to reboot the device and apply the new Device Number.
Wireless Settings - Wireless Access Overview (MVP-5150
Only)

DHCP

When choosing DHCP, a DHCP server must be accessible before the fields are populated.
If the SSID and WEP fields have not previously been configured, the Wireless
Settings page will not work until the panel is rebooted.
MVP touch panels connect to a wireless network through their use of the pre-installed AMX 802.11g
wireless interface card. This allows users to communicate with an Access Point (AP). The AP
communication parameters must match those of the pre-installed wireless interface card installed within
the panel. This internal card transmits data using 802.11x signals at 2.4 GHz. For a more detailed
explanation of the new security and encryption technology, refer to the Appendix B: Wireless
Technology section on page 165.
For more information on utilizing the AMX Certificate Upload Utility in conjunction with the EAP
security, refer to the AMX Certificate Upload Utility section on page 170.
MVP-5100/5150 5.2" Modero Viewpoint Touch Panels
Configuring Communication
25