AMX MVP-5200i-GB Instruction Manual page 56

Wireless Settings Page (Cont.)
IP Settings:
DHCP/STATIC
IP Address
Subnet Mask
Gateway
Host Name
Primary DNS
Secondary DNS
Domain
MAC Address
Active Roaming on
Channels 1,6,11
Access Point
MAC Address:
Information/
Configuration:
Security Mode:
Security Type:
SSID:
Channel:
Signal Level Value:
Signal Level:
Security Mode buttons: Security for WiFi connections is available in Simple Mode or Enterprise Mode. Touch the appropriate button to
Some encryption and security features may or may not be supported:
Wireless Security Support
802.11g Wi-Fi CF card:
Refer to the Conf iguring Wireless Network Access section on page 29 for more information on configuring the panel for wireless
network access using the various security options.
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Sets the IP communication values for the panel:
Sets the panel to either DHCP or Static communication modes.
• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP server. If DHCP is selected, the other IP
Settings fields are disabled (see below).
• Static IP is a permanent IP Address assigned to the panel. If Static IP is selected, the other IP Settings fields
are enabled (see below).
Enter the secondary IP address for this panel.
Enter the subnetwork address for this panel.
Enter the gateway address for this panel.
Enter the host name for this panel.
Enter the address of the primary DNS server used by this panel for host name lookups.
Enter the secondary DNS address for this panel.
Enter a unique name to the panel for DNS look-up.
This unique address identifies the wireless Ethernet card in the panel (read-only).
When enabled, connection allows active roaming between APs by switching between channels 1, 6, and 11 if the
other channel is unavailable.
This unique address identifies the Access Point (AP) used by this panel for wireless communication (read-only).
• Site Survey button: Launches the Wireless Site Survey page. The options on this page allow you to detect
("sniff-out") all APs transmitting within range of the panel's Wi-Fi card.
Data displayed on the Site Survey page is categorized by:
- Network Name (SSID) - AP names
- Channel (RF) - channels currently being used by the AP
- Security Type - security protocol enabled on the AP, if detectable
- Signal Strength - None, Poor, Fair, Good, Very Good, and Excellent
- MAC Address - Unique identification of the transmitting Access Point
• Refer to the Using the Site Survey Tool section on page 30 for more detailed information on the Site Survey
page.
Displays the current wireless configuration settings.
Displays the currently selected security mode within the Simple or Enterprise security modes. This may be
changed within the Simple or Enterprise Security mode popup windows (for more information, please refer to the
Security Modes on page 57).
Displays the currently selected Security Mode: Simple or Enterprise.
Displays the currently used SSID of the target AP.
The RF channel being used for connection to the AP (read -only).
This indicator displays a description of the signal strength of the Access Point signal.
Provides a graphical representation of the Signal Level Value.
open the pop-up window for each mode.
• Open (Clear Text)
• Static WEP (64-bit and 128-bit key lengths)
• WPA-PSK
• EAP security (with and without certificates)
• AP Site Survey
Protected Setup Pages
56