Table of Contents
Advertisement
NOTE: Make sure to measure the size of the intended hole before starting to cut it.
2.
Select the knockout to be removed from the top of the box. The box has two knockouts, at the top left and the top right.
NOTE: To assist with wiring, and to avoid mechanical stresses on the wire and the mechanism of the Wall-Mounted Charging
Station, the top right knockout is preferred for use.
3.
Run the power cable through the knockout into the box. Pull out about six inches (15.25cm) of cable into the box to facilitate
installation of the MVP-WCS-52.
4.
Slide the plastic back box into the hole, being careful not to twist or pinch the cable, and set it flush with the wall (FIG. 11).
Make sure that all of the lockdown wings are folded into their slots before attempting to insert the box.
For ease of installation, the inside of the box has the direction "UP" labeled for reference.
Note Orientation Designator
Installation of plastic back box
FIG. 11
5.
Extend the wings on the sides of the box by tightening the screws inside the box.
Not all of the wings must be extended to lock the box in place, but extending a minimum of the top and bottom wings is
highly recommended.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the wing will tighten up
against the inside of the wall.
NOTE: Make absolutely certain that the box is in its intended position. Once the box lockdown wings are extended within the box's
hole within the wall, removing the box will be extremely diff icult without damaging the wall in the process.
NOTE: The maximum recommended torque to screw in the wings on the plastic back box is 105 IN-OZ [74 N-CM]. Applying
excessive torque while tightening the wing screws, such as with powered screwdrivers, can strip out the wings or damage the
plastic back box.
6.
Prepare the captive wires for the 2-pin 3.55 mm mini-captive wire connector used for the MVP-WCS-52's power supply:
NOTE: Preparing and connecting the captive wires requires the use of a wire stripper and flat-blade screwdriver.
Strip 0.25 inch (6.35 mm) of wire insulation off all wires.
Insert each wire into the appropriate opening on the connector.
Turn the screws clockwise to secure the wires in the connector. Do not over-torque the screws; doing so can bend the
seating pins and damage the connector.
7.
Secure the power cable to the device, using either of the two tie-wrap anchors included in the Installation Kit at the top rear of
the device (FIG. 12).
Point the head of each tie wrap toward the center of the device.
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
All lockdown wings folded flat during installation
Accessories
23
Advertisement
Table of Contents
