4024-110
Exit 1 media shift assembly removal
1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Remove the top rear cover. See
4.
Open the printer left door assembly.
5.
Remove the standard exit top cover. See
6.
Open the printer front door assembly. See
7.
Remove the front left cover. See
8.
Remove the two screws securing the bracket (A).
9.
Remove the bracket (A) by lifting it upward.
10.
Remove the exit 1 drive belt. See
Note: Disconnect the two connectors from the sensor (exit 1 media shift) and the sensor (exit 1 bin full).
4-104
Printer Service Manual
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Top cover assembly removal" on page
"Standard exit 1 top cover removal" on page
"Printer front door assembly removal" on page
"Printer front left cover removal" on page
"Exit 1 media shift assembly removal" on page
A
4-125.
4-14.
4-7.
4-112.
4-8.
4-3.
4-104.
Previous
Next
Go Back