Table of Contents
Advertisement
MBT-5003 L-Band Up/Down Converter System
Ethernet Management
6.5.5.3.2
Config | Utility
The 'Config | Utility' page (Figure 6-7) is used to configure MBT-5003 base unit operating
parameters.
Date and Time
•
The user may enter a date in the form MM/DD/YY (where MM = month [01 to 12],
DD = day [01 to 31], and YY = year [00 to 99]).
•
The user may enter a time using HH:MM:SS format (where HH = hour [00 to 23],
MM = minutes [00 to 59], and SS = seconds [00 to 59]).
Click [Change Date/Time] as needed once the desired date and time have been entered here.
Circuit ID
The user may create a Circuit ID string of up to 24 characters. Click [Change CID] once the
desired string has been entered here.
Current Active Firmware Image (read-only)
The selected Current Active Firmware Image is identified here. In this example, Image 2 is the
Current Active Firmware Image.
Next Reboot Image
Using the drop-down menu, select the Next Reboot Image as 1 or 2, then press [Submit] when
done.
Perform Soft Reboot
Click [Reboot Now] to reboot the MBT-5003 using the Current Active Firmware Image.
Figure 6-7. Config | Utility page
6–16
Revision 1
MN-MBT5003
Advertisement
Table of Contents
