Table of Contents
Advertisement
MBT-5003 L-Band Up/Down Converter System
Preface
EN55082-1 – 1997 Compliance
This equipment meets the EMC/generic immunity standard as defined per EN55082-1 1997.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference; in which case,
users are required to correct the interference at their own expense.
To ensure compliance, properly shielded cables for DATA I/O shall be used. More
specifically, these cables shall be shielded from end to end, ensuring a
NOTE
continuous shield.
Safety Compliance
EN60950
Applicable testing is routinely performed as a condition of manufacturing on all units to ensure
compliance with safety requirements of EN60950. This equipment meets the Safety of Information
Technology Equipment specification as defined in EN60950.
Low Voltage Directive (LVD)
The following information is applicable for the European Low Voltage Directive (2006/95/EC):
<HAR>
!
International Symbols:
Symbol
For additional symbols, refer to Cautions and Warnings listed earlier in this Preface.
NOTE
Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
Definition
Alternating Current
Fuse
Symbol
Protective Earth / Safety Ground
Chassis Ground
xi
Revision 1
MN-MBT5003
Definition
Advertisement
Table of Contents
Need help?
Do you have a question about the MBT-5003 and is the answer not in the manual?
Questions and answers