Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 51


.Step 18
Move.the.throttle.stick.and.trim.to.low..Check.to.make.
sure.the.carburetor.will.move.to.the.closed.position.when.
operating.the.servo..Install.an.3mm.x.8mm.screw.to.
secure.the.easy.connector.to.the.throttle.pushrod..Check.
the.movement.of.the.throttle.to.verify.there.is.no.binding.
at.either.low.or.high.throttle,.and.that.the.carburetor.can.
move.through.the.full.range.of.movement..If.there.is.any.
binding,.make.the.necessary.adjustment.to.eliminate.
any.binding..Install.the.throttle.servo.arm.screw.when.
complete.
 
. .Step 19
Position.the.control.horn.on.the.aileron.so.the.horn.aligns.
with.the.hinge.line.of.the.aileron..Mark.the.position.for.the.
mounting.holes.using.a.felt-tipped.pen.
Section 15: Linkage Installation
 
. .Step 20
Drill.three.3/32".(2mm).holes.through.the.ailerons.at.the.
locations.marked.in.the.previous.step.
 
. .Step 21
Place.2–3.drops.of.thin.CA.into.the.hole.to.harden.the.
wood..This.will.eliminate.the.potential.of.the.screw.
crushing.of.the.wood..Repeat.this.for.each.of.the.three.
holes.
51