Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 50

Section 15: Linkage Installation

.Step 14
Slide.the.pushrod.into.the.fuselage.from.the.front..Make.
any.necessary.bends.in.the.pushrod.wire.to.attach.it.to.the.
steering.arm..Make.sure.it.will.not.interfere.with.the.nose.
gear.rail.when.it.is.installed.
Note:.Steps.12.through.14.show.the.retract,.
but.the.procedure.is.identical.for.fixed.gear.

.Step 15
Mark.the.pushrod.where.it.crosses.the.holes.in.the.servo.
arm..Bend.the.wire.90.degrees.at.the.mark.made.in.the.
previous.step..Slide.the.wire.through.the.center.hole.in.
the.rudder.servo.arm..Secure.the.wire.using.a.nylon.wire.
keeper.
50

.Step 16
Use.a.3/32".(2.5mm).drill.bit.to.drill.out.the.holes.in.a.
servo.arm..Attach.an.easy.connector.to.the.arm.using.a.
connector.back.plate.

.Step 17
Center.the.throttle.stick.and.trim.with.both.the.receiver.
and.transmitter.on..Slide.the.easy.connector.onto.the.
throttle.pushrod..Install.the.throttle.servo.arm.in.the.
neutral.position.as.shown.