Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 35


.Step 17
Select.a.servo.arm.from.those.included.with.your.servo.
that.has.a.distance.of.1/2".(13mm).from.the.center.of..
the.arm..Use.a.3/32".(2.5mm).drill.bit.to.drill.the.
appropriate.holes.in.the.arm..Attach.a.large.quick.
connector.(not.included).to.the.servo.arm.using.a..
quick.connector.retainer.
Section 9: Retract Linkage Installation

.Step 18
Connect.the.retract.servo.to.your.radio.system.and.
electronically.move.the.servo.to.the.retracted.position..
Slide.the.retract.control.wire.through.the.easy.connector.
as.shown.and.secure.the.servo.wheel.to.the.retract.servo..
With.the.retract.servo.in.the.retracted.position,.push.the.
retract.linkage.to.manually.retract.the.landing.gear..Install.
a.4-40.x.1/4".screw.into.the.easy.connector.and.tighten.it.
to.secure.the.retract.linkage.

.Step 19
Cycle.the.retract.system.several.times.to.make.sure.there.
is.no.binding..Also.check.to.verify.the.gear.locks.in.both.
the.extended.and.retracted.positions..Make.any.necessary.
adjustments.to.be.sure.the.retracts.are.working.and.
locking.correctly.
35