Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 27


.Step 5
Drill.the.locations.marked.in.the.previous.step.using.a.
3/32".(2.5mm).drill.bit.

.Step 6
Mark.the.location.on.the.firewall.for.the.retract.actuator.
lever.

.Step 7
Drill.the.location.marked.in.the.previous.step.using.a.1/4".
(6mm).drill.bit.
Section 8: Retract Installation

.Step 8
Attach.the.nose.gear.using.four.3mm.x.12mm.sheet.metal.
screws.

.Step 9
Slide.the.axle.supplied.with.the.retracts.onto.the.nose.
gear.wire..Temporarily.secure.the.axle.using.the.supplied.
screws..Adjust.the.position.of.the.axle.until.the.nose.gear.
1
is.positioned.5 / ".(134mm).from.the.nose.gear.mount.as.
.
4
shown..Tighten.the.screw.to.secure.the.axle.to.the.nose.
gear.wire..Use.a.rotary.tool.and.cut-off.wheel.to.remove.
the.excess.nose.gear.wire.
27