Section.9:.Retract.linkage.installation - Hangar 9 T-34 Mentor 40 ARF Assembly Manual

Section 9: Retract Linkage Installation
Required Parts
•.Large.quick.connector.(3). •.Metal.clevis.(3)
•.Clevis.retainer.(3).
•.4-40.x.7".threaded.rod.(2). •.4-40.x.9
•.Wing.retract.servo.tray
•.Fuselage.retract.servo.tray
•.Quick.connector.retainer.(3)
Required Tools and Adhesives
•.6-minute.epoxy.
•.Drill.
•.Drill.bit:.1/16".(1.5mm),.3/32".(2.5mm),.1/4".(6mm)
•.Retract.Servo.(JRPS703)
•.Retract.Servo.(JRPS513)

.Step 1
Locate.the.wing.retract.servo.tray..Use.6-minute.epoxy.to.
glue.the.servo.tray.into.position..The.wide.edge.of.the.tray.
will.be.positioned.towards.the.leading.edge.of.the.wing.
•.4-40.x.1/4".screw.(3)
1
/ ".rod
.
4
•.3/32".hex.wrench
•.Thick.CA

.Step 2
Install.a.low-profile.retract.servo.in.the.wing.retract.servo.
tray.using.the.hardware.provided.with.the.servo..Prevent.
splitting.the.servo.tray.by.drilling.1/16".(1.5mm).holes.for.
the.servo.mounting.screws.
 
. .Step 3
Slide.a.clevis.retainer.onto.a.clevis..Attach.the.clevis.to.a.
4-40.x.7".threaded.pushrod.
31