Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 32

Section 9: Retract Linkage Installation
 
. .Step 4
Install.the.linkage.into.the.wing..Attach.the.clevis.to.the.
retract.actuator..
Note:.Make.a.bend.in.the.pushrod.so.the.
pushrod.will.be.positioned.as.close.to.the.top.
of.the.wing.sheeting.as.possible.to.provide.
clearance.for.the.wheel.when.retracted.
 
. .Step 5
Select.a.servo.arm.from.those.included.with.your.servo.
that.has.a.distance.of.approximately.7/8".(22mm).between.
equally.spaced.holes.as.shown.
32
 
. .Step 6
Use.a.3/32".(2.5mm).drill.bit.to.drill.the.appropriate.holes.
in.the.arm.
 
. .Step 7
Attach.a.large.quick.connector.(not.included).to.the.servo.
arm.using.a.quick.connector.retainer.