Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 33

 
. .Step 8
Connect.the.retract.servo.to.your.radio.system.
and.electronically.move.the.servo.to.the.retracted.position..
Slide.the.retract.control.wire.through.the.easy.connector.
as.shown.and.secure.the.servo.arm.to.the.retract.servo.
 
. .Step 9
With.the.retract.servo.in.the.retracted.position,.push.the.
retract.linkage.to.manually.retract.the.landing.gear..Install.
a.4-40.x.1/4".screw.into.the.easy.connector.and.tighten.it.
to.secure.the.retract.linkage.
Section 9: Retract Linkage Installation

.Step 10
Repeat.Steps.3.through.9.for.the.remaining.main.
gear.retract.

.Step 11
Slide.a.clevis.retainer.onto.a.clevis..Attach.the.clevis.to.a.
1
4-40.x.9 / ".threaded.pushrod.
.
4

.Step 12
Drill.a.1/4".(6mm).hole.in.former.2.centered.between.the.
nose.gear.rails..The.center.of.the.hole.will.be.3/4".(19mm).
below.the.edge.of.the.former.as.shown.
33