Section.2:.Installing.the.horizontal.stabilizer - Hangar 9 T-34 Mentor 40 ARF Assembly Manual

Section 2: Installing the Horizontal Stabilizer
Required Parts
•.Assembled.wing.
•.Stabilizer
•.1/4-20.x.2".nylon.bolts.(2)
Required Tools and Adhesives
•.Screwdriver.(slotted).
•.Felt-tipped.pen.
•.Drill.bit:.1/4".(6mm).

.Step 1
Place.the.wing.onto.the.fuselage.and.check.the.fit..Make.
any.adjustments.necessary.to.the.wing.bolt.holes.and.
attach.the.wing.using.the.two.1/4-20.x.2".nylon.bolts.

.Step 2
Measure.and.mark.a.centerline.on.the.stabilizer.
•.Fuselage
•.Hobby.knife
•.Drill
•.Square

.Step 3
Measure.from.the.trailing.edge.of.the.stabilizer.1
(30mm)..Use.a.felt-tipped.pen.to.mark.this.location.

.Step 4
Drill.a.hole.at.the.location.marked.in.the.previous.step.
using.a.1/4".(6mm).drill.bit..It.is.highly.suggested.to.use.
a.drill.press.to.make.sure.the.hole.is.perpendicular.to.the.
stabilizer.
3
/ ".
.
16
11