Section.14:.Radio.installation - Hangar 9 T-34 Mentor 40 ARF Assembly Manual

Section 14: Radio Installation
Required Parts
•.Fuselage.assembly.
•.Servo.w/hardware.(5)
Required Tools and Adhesives
•.Drill
•.Drill.bit:.1/16".(1.5mm),.3/32".(2.5mm)
•.Phillips.screwdriver.(small)
•.9".Servo.Extension.(JRPA097).(2)

.Step 1
Install.the.recommended.servo.hardware.(grommets.and.
eyelets).supplied.with.your.radio.system.onto.five.servos.
(elevator,.rudder,.throttle.and.2.ailerons).

.Step 2
Temporarily.install.the.rudder,.elevator,.and.throttle.servos..
Mark.the.locations.for.the.servos.screws.using.a.felt-
tipped.pen.
•.Wing.assembly

.Step 3
Remove.the.servo.and.drill.the.holes.for.the.servo.
mounting.screws.using.a.1/16".(1.5mm).drill.bit.
Hint:.Place.a.drop.of.thin.CA.onto.
each.screw.hole.to.harden.the.wood.
around.the.hole..Allow.the.CA.to.fully.
cure.before.installing.the.servos.

.Step 4
Secure.the.servos.using.the.screws.provided.with.the.
servos.
43