Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 10

Section 1: Joining the Wing Halves

.Step 5
Completely.coat.one.half.of.the.each.wing.joiner.with.
epoxy..Be.sure.to.apply.epoxy.to.the.top.and.bottom.of.the.
joiner.also..Insert.the.epoxy-coated.side.of.the.joiner.into.
the.wing.joiner.cavity.up.to.the.mark.on.the.joiner..If.you.
have.used.enough.epoxy,.it.will.ooze.out.of.the.cavity.as.
the.joiner.is.installed..Remove.any.excess.epoxy.using.a.
paper.towel.and.rubbing.alcohol.

.Step 6
Apply.a.generous.amount.of.epoxy.to.the.joiner.cavity.of.
the.opposite.wing.panel.

.Step 7
Apply.epoxy.to.the.exposed.portion.of.the.wing.joiner.

.Step 8
Apply.epoxy.to.root.wing.rib.of.both.panels.
10

.Step 9
Carefully.slide.the.wing.panels.together..Apply.enough.
pressure.to.firmly.seat.the.two.wing.panels.together,.
causing.any.excess.epoxy.to.ooze.out.from.between.the.
panels..Use.rubbing.alcohol.and.a.paper.towel.to.remove.
the.excess.epoxy..Check.to.make.sure.there.are.no.visible.
gaps.between.the.panels.

.Step 10
Use.masking.tape.to.securely.hold.the.wing.panels.
together..Place.the.wing.assembly.back.onto.the.work.
surface.(covered.with.wax.paper).and.check.the.dihedral.
angle..Allow.the.epoxy.to.fully.cure.before.continuing.to.
the.next.section.