Hangar 9 T-34 Mentor 40 ARF Assembly Manual page 48

Section 15: Linkage Installation

.Step 4
Bend.the.wire.90.degrees.at.the.mark.made.in.the.
previous.step.

.Step 5
Slide.the.wire.through.the.outer.hole.in.the.elevator.servo.
arm..Secure.the.wire.using.a.nylon.wire.keeper.
48

.Step 6
Thread.the.rudder.control.horn.onto.the.rudder.control.
wire.until.the.outer.edge.of.the.horn.is.flush.with.the.end.
of.the.wire.

.Step 7
Slide.a.clevis.retainer.onto.a.nylon.clevis..Thread.
1
a.clevis.onto.the.23 / ".assembled.pushrod.a.minimum..
.
4
of.10.turns.

.Step 8
Slide.the.pushrod.assembly.into.the.fuselage.from.the.
radio.compartment..Make.sure.the.pushrod.goes.through.
the.outer.hole.in.the.fuselage.former..Attach.the.clevis.to.
the.rudder.control.horn..Make.adjustments.to.the.pushrod.
and.fuselage.to.provide.free.movement.of.the.rudder.and.
pushrod.