Section.13:.Electric.motor.installation - Hangar 9 T-34 Mentor 40 ARF Assembly Manual

Section 13: Electric Motor Installation
Required Parts
•.Fuselage
•.8-32.x.1/2".screw.(4).
Required Tools and Adhesives
•.Phillips.screwdriver.
•.Drill.
•.Male.Deans.connector.(3). •.Soldering.iron
•.Drill.bit:.9/64".(3.5mm),.7/32".(5.5mm)
•.Female.Deans.connector.w/wire
•.EP.Motor.Mount.(HAN4245)
•.4200mAh.2S2P.7.4V.Li-Po.(2)
Note:.Although.the.T-34.Mentor.was.not.
designed.as.an.electric.aircraft,.it.can.be..
easily.converted.to.electric.by.using.the..
Hangar.9 ® .Electric.Mount.and.a.little.ingenuity.

.Step 1
Position.the.electric.motor.mount.so.the.outer.edge.of.
the.mount.is.aligned.with.the.outer.edge.of.the.plywood.
spacer.on.the.firewall..Use.a.felt-tipped.pen.to.mark.the.
locations.for.the.mounting.holes.on.the.electric.mount.
40
•.8-32.blind.nut.(4)
•.Threadlock
•.Solder

.Step 2
Drill.the.locations.marked.in.the.previous.step.using.a.
7/32".(5.5mm).drill.

.Step 3
Attach.the.motor.mount.to.the.firewall.using.the.four..
8-32.x.1/2".machine.screws,.four.8-32.washers.and.the.
four.8-32.blind.nuts.that.were.included.in.the.kit....
Apply.threadlock.on.the.screws.to.prevent.them.from.
vibrating.loose.