Figure 79
Replacement
246
SAN140M Installation and Service Manual
11. Remove the AC modules
12. Remove the fan modules
13. Remove the SBAR assemblies
14. Unplug the Power/System LED assembly cable from the
backplane.
15. The card cage and backplane are secured to the director chassis
with 6 panhead Phillips screws. Use a standard Phillips
screwdriver to remove these screws.
16. Remove the card cage and backplane assembly
Backplane removal and replacement
17. Disconnect the maintenance port cable from the backplane.
18. The backplane is secured to the card cage with 7 panhead Phillips
screws. Use a standard Phillips screwdriver to remove these
screws.
19. Remove the backplane (PWA and frame as one FRU) from the
card cage. Place the backplane in an anti-static bag to provide
ESD protection.
To replace the backplane and all FRUs disconnected from the
backplane:
(RRP: AC module
on page 232).
(RRP: Fan module
on page 235).
(RRP: SBAR assembly
(Figure
on page 241).
79).