Power Backplane/Backplate Assembly Removal - IBM xSeries 240 81Y Hardware Maintenance Manual

Power backplane/backplate assembly
removal
Before you begin:
Read "Safety information" on page 224.
Notes
1. The illustrations in this book are similar to the
server; details might vary.
2. To replace the power backplane/backplate
assembly, reverse this procedure.
To remove the power backplane/backplate assembly, do
the following.
1. Power-off the server and all external devices; then,
disconnect the server from the power source.
2. Remove the server cover. See "Removing the
left-side cover (tower model)" on page 99 or
"Removing the cover (rack model)" on page 100.
3. Remove the power supplies. See "Installing a
hot-swap power supply" on page 131.
4. Disconnect the power backplane/backplate assembly
cables.
5. Release the power backplane/backplate assembly
latch 1 ; then, slide the power backplane/backplate
assembly 2 out of the server.
91
xSeries 240