Table of Contents
Advertisement
Figure 62
Download and install firmware
Clean fiber-optic components
3. Gently wipe the end-face and other surfaces of the connector with
an alcohol pad (part 2 of
contact with the surface to be cleaned. Wait approximately five
seconds for cleaned surfaces to dry.
4. Repeat
step 2
and
step 3
5. Repeat
step 2
and
step 3
then reconnect the fiber-optic cable to the port.
The firmware version shipped with the product is provided on the
System Version XX.YY.ZZ CD-ROM. Subsequent (upgrade) firmware
versions are provided to customers through IBM.
NOTE: When upgrading firmware or software, follow all procedural
information contained in release notes or engineering change (EC)
instructions that accompany the version. Such information supplements
information provided in this general procedure.
1. To obtain the latest level of firmware, go to:
http://www.ibm.com/servers/storage/support/san/index.html.
Locate the link for this Switch and then select the link for
downloading firmware.
2. Follow the instructions for downloading the firmware.
3. Transfer the downloaded firmware file to the management server
or PC communicating with the interface. Use a diskette,
CD-ROM, or other electronic means.
4. From there, install the firmware as described in this guide.
1
Figure
62). Ensure the pad makes full
of this procedure (second cleaning).
of this procedure again (third cleaning),
Chapter 4: Repair information
2
195
Advertisement
Chapters
Table of Contents
